Six Considerations pneumatic punch
  Because of the pressure cylinder pneumatic presses often in high-speed operation status , likely to cause the machine to wear, so the operating instructions should be operating , pressurized cylinder operating temperature of about -5 ℃ ~ 60 ℃, the operating speed 50 ~ 1000mm / s, in order work to ensure that pressurized cylinder , use should note the following:
1 , keep it clean in front of the pressurized gas cylinders access road , please first piping and components within the dust and debris cleared , so reducing the pressure cylinder life.
2 , within the normal pressure range use , cylinder working pressure must be in accordance with the inspection report specified operating pressure range in normal use , shall not exceed the working pressure.
3, note pressurized cylinder working environment. Cylinders are designed to work within the environment temperature has been set, Ruoyin work to transform the work environment over temperature and pressure cylinder technology required to contact the relevant personnel at . Pneumatic cylinder presses in some components due to iron, so please do not place it in industrial environments specially designed for use within a complex environment (if any exposure to environmental chemicals ) , and the other in the front of the installation of effective air cylinder handling components ( FRL ) and lubrication and drainage treatment access .
4 , can not be tampered plus other hydraulic oil. Pressurized cylinder chosen in the design of hydraulic oil quality as VG68 # hydraulic oils , irrevocable unauthorized use other liquid media ( such as oil, water, etc. ) .
5 , according to a certain program operation. Action program of work in accordance with the action program must be equipped with pneumatic figure that preloading action - action supercharger boost pressure release - pre-press reset.
6 , attention to maintenance, always check the pressure cylinder operation . Pneumatic presses in order to avoid pressure cylinder supercharged action when excessive damage your mold or workpiece , please install the booster segments into the entrance of a valve, in order to effectively protect your product . To ensure the stability of the pressurized cylinder work , we recommend the installation of a gas cylinder in parallel as possible between FRL and pressurized cylinder . When using a pressurized cylinder more than 500,000 times or more than six months , it is recommended hydraulic oil cylinder to replace all the time , in order to improve the life and work life of the cylinder .